Torqit Patrol Y62 5.6L Series 1 - Series 5 (01/2013 on ) Performance Exhaust Headers

PERFORMANCE HEADERS FOR NISSAN Y62 5.6L SERIES 1 – Series 5 PATROL: 2013 to Current
If you’re searching for the best exhaust for your Y62 Patrol, performance headers are a powerful place to start. The key role of Performance Headers is to replace your vehicle’s restrictive exhaust manifolds for increased flow and a boost in engine performance. Whether you’re looking to get more power out of your 4WD, or simply reduce strain on the engine when towing or under load; Torqit Performance Headers will increase exhaust flow for an overall improvement in power, note, and efficiency.

Torqit’s Performance Headers for the Y62 Nissan Patrol are a long tube design, mandrel bent and manufactured here in Australia. The length and smooth, constant diameter of the pipes helps reduce back pressure, increasing the air ratio and helping the engine work at maximum capacity. Dependent on driving behavior, this can significantly improve the Patrol’s fuel economy when cruising long distances at a constant speed.

Torqit’s Y62 Headers are fully ceramic coated which provides long-term protection, performance and preserves the sleek finish. Acting as a thermal barrier, Torqit’s Turbo X coating is rated to 1000 degrees, and can withstand high temperatures and corrosion without cracking or flaking.

PERFORMANCE HEADER FEATURES

Long Tube Primary Pipes
Torqit’s Y62 Performance Headers are a long tube design, which means the pipe merge together further away from the engine. This design helps reduce back pressure, improves exhaust flow, and builds extra torque and horsepower throughout the rev range. A long tube design additionally improves the ‘scavenging process’, through which the exhaust gas in each engine cylinder is replaced with fresh air for the next cycle. This provides maximum airflow for the engine to work at full capacity.

Mandrel Bent Steel
Made in Australia, Torqit’s Performance Headers are mandrel bent from a premium quality steel. Thinner and smoother than the rough cast iron walls of factory manifolds, the constant diameter of each pipe allows for unrestricted exhaust flow, without stalling or back pressure. A Mandrel Bender guarantees 100% accuracy and repeatability, which is key to the headers aligning during install. Watch Torqit’s Mandrel Bender in action here.

Tough Ceramic Coating
An ultra-tough ceramic coating provides a powerful thermal barrier, which reduces temperatures and corrosion for long-term protection and performance. Rated to 1000 degrees, Torqit’s Turbo X Ceramic Coating is capable of withstanding extreme temperatures without cracking or flaking. As a result, the header will last longer plus maintain its sleek finish.

Pair With Full Y62 Exhaust System and High Flow Cats
For the ultimate performance upgrade and savings, pair with Torqit’s Y62 Performance Exhaust and High Flow Catalytic Converters. The exhaust runs from twin 3” pipes into a single 3” tailpipe, and is designed to produce a powerful V8 note without cabin drone. Combined with the reduced CPSI (cells per square inch) of Torqit’s high flow cats, a full exhaust upgrade offers optimum power and torque, improved fuel efficiency, reduced EGT’s and a deep note.